ICONICO

Discussion Forum

Post Reply in Screen Tracing Paper

Post Reply To "FAQ: How to Calibrate the Screen Tracing Paper"
If you would like to calibrate the Screen Tracing Paper's units to match the drawing you're measuring then follow these instructions:

1. Click 'New' to create a new sheet.

2. Make sure 'Pixels' is selected in the 'Units' dropdown.

3. Click the 'Add' tool.

4. Click on the edge of the item you want to calibrate from, which should be a known distance.

5. Move the mouse to hover over the end of the item that you want to calibrate, but DO NOT CLICK.

6. At this point note the Circumference readout, which will be the distance in pixels of the item you want to calibrate from.

7. Click the 'Configure' button, the 'Configure Custom Units' popup will open.

8. Click 'Add Unit'

9. Type a descriptive name under 'Unit Name'

10. In the 'Number of Pixels' box enter the exact number you measured and noted earlier.

11. In the 'Length in Units' enter how many real life units the item is that you calibrated from, for example, if it is 3 feet then enter '3'.

12. Click 'OK'

Subject

First Name

Last Name

Email Address for reply notifications (optional) - your email will not be visible

Re-enter the text shown in the image
Enter the text shown here below  

Your Message

  Cancel

Our Software Stores

IconicoAccurate Design and Development Software

BitsDuJourDiscount Deal Coupons for Windows and Mac Software Apps

Our Software Services

SoftwareMarketingResourceYou Wrote the Code, Now How do you Sell it?

IcoBlogOur Official Blog

© copyright 2004-2020 Iconico, Inc. Code & Design. All Rights Reserved. Terms & Conditions Privacy Policy Terms of Use